Developed for the trade show, convention and audio visual industries, these ADJUSTABLE UPRIGHTS are used for "PIPE and DRAPE SYSTEMS" worldwide. Designed specifically to be used with our LOW PROFILE BASE ASSEMBLIES and TWIST-LOK TELESCOPIC DRAPE SUPPORTS, to create an endless selection of show booth and structure combinations. Our ADJUSTABLE UPRIGHTS are available from stock in the sizes listed herein to meet your specific requirements. Other sizes can be fabricated for your special applications. STANDARD MODELS IN STOCK 2 PIECE 3 PIECE 3' to 5' 9' to 16' 5' to 11' 4' to 7' 10' to 18' 6' to 14' 5' to 8' 11' to 20' 7' to 17' 6' to 10' 12' to 22' 8' to 20' 7' to 12' 13' to 24' 9' to 23' 8' to 14' 14' to 26' -- MODEL SIZE INFORMATION The small number is the collapsed height of the upright assembly when NOT installed on a base assembly. Use this number for storage and transportation considerations. The larger number is the maximum set height with a conservative overlap between the inner and outer poles. EXAMPLE: Model No. 9' - 16' (2 piece) MINIMUM SET HEIGHT (On base assembly with 6" pin) = 9' - 6" COLLAPSED HEIGHT (Off Base Assembly) = 9' MAXIMUM SET HEIGHT = 16' FEATURES Easy to set-up, accurate and rapid height adjustments No knobs or wing nuts to adjust. Quickly adjusts to any height within the specific model range. All component surfaces have protective coatings against rust and corrosion. No tools required for set-up or disassembly. Standard models in stock are available from 3 1/2 feet to 30 foot heights

WARNING:The intended use of this equipment is to support lightweight fabric screening. Any other use is entirely at the risk of user.

SLIP-LOK HOW IT WORKS The SLIP-LOK collar assembly locks automatically when the inner pole is raised vertically to the desired height. As a vertical load is applied downward, the ball taper lock feature locks tighter. The more pressure applied downward the tighter it will lock. To release the lock, simply raise the inner pole slightly and lift the release ring. For SAFETY, hold the inner pole firmly while raising or lowerong the height

REPAIR PARTS AND EXTENDERS REPAIR ENDS Damaged slot areas at the top can be cut off and replaced with a repair end secured with a pop rivet. COLLAR ASSEMBLIES Damaged locking collar assemblies can be cut off and replaced with new collar assemblies. EXTENDERS Upright heights can be temporarily increased by installing extenders of various heights.

Exclusively Expo 1225 Naperville Dr. Romeoville, IL 60446 Phone: 630-378-4600 Fax: 630-378-4617

Exclusively Expo 4006 S. 23rd St. Phoenix, AZ 85040 Phone: 602-276-0586 Fax: 602-276-0794